.. TBot installation Installation ============ Clone the `TBot repository `_, then install TBot using :: python3 setup.py install --user Also, if you haven't done this already, you need to add ``~/.local/bin`` to your ``$PATH``. Troubleshooting --------------- If the installation does not work, most likely it is an error when installing paramiko. I recommend installing paramiko through your distros package manager (eg. ``python3-paramiko`` for Fedora). If your distros version of paramiko is too old, you will then need to install paramiko with pip (after installing the distro package):: pip3 install --user paramiko Completions ----------- TBot supports command line completions. Enable them by adding :: source /path/to/tbot/completions.sh to your ``.bashrc`` or equivalent. Development ----------- If you intend to work on TBot itself, you can install it in development mode:: python3 setup.py develop --user This does not install TBot like usual, but symlinks the installation to the repository, so any changes you make are instantly available, without the need of reinstalling every time.